About Flashing tool(Odin)

Home  >>  About Flashing tool(Odin)

About Flashing tool(Odin)

On May 28, 2019, Posted by , With 4 Comments


Hello guys,

hope everything goes well on you.

what will effect the Odin flashing speed?

power voltage of the USB?

if so, how can we able to have the equipment that

can able to flash multiple quantities and the speed will be fast,

not just 10~15 mins,

following will be the image of the MASS D/L of the Odin,

just curious,

/

https://imgur.com/LXgEMZ6

Thank you,

BR

4 Comments so far:

  1. killu says:

    I use the MASS D/L on odin often, flashing up-to 20 devices at once. Motherboard quality/USB power controllers will make a difference to speed. All USB ports I run are powered USB 3.0 or 3.1 – Cables also take affect Genuine microsoft USB 3.0 type C cables increased speed by 10 sec a handset compared to cheap (ebay) or Samsung USB C cables – cost a lot more so not worth the time saving.

    nAlthough at the end of the day the handset is the final factor in speed. How fast it can process the firmware file not the speed delivering the data to it. What handsets are you flashing in 10-15 minutes. I don’t process any that take more than 7 minutes most are 2-5 minutes connected to Odin.

  2. Metaton-alfred says:

    We are running 2 hubs like this but gen 2, highly recommended https://www.cambrionix.com/products/…strial-usb-hub (that’s not advertising, just very satisfied Along with its performence, hence recommendation)

  3. igglo7pays says:

    I always found any form of external hub greatly increases time

    rnUse direct ports on Motherboard and powered PCI express USB 3.0 cards (expensive/decent brand). J600FN take about 3 minutes each port. T585 down to 1.40 to 2 minutes.

  4. RandikPixie says:

    I recommend TP-LINK UH720 hub… It is really fast and reliable…