iPad 2 lock button not working after digitiser replacement – lot of problems ! its some previous iphone pone problem

Home  >>  iPhone  >>  iPad 2 lock button not working after digitiser replacement – lot of problems ! its some previous iphone pone problem

iPad 2 lock button not working after digitiser replacement – lot of problems ! its some previous iphone pone problem

On January 27, 2015, Posted by , In iPhone, With Comments Off on iPad 2 lock button not working after digitiser replacement – lot of problems ! its some previous iphone pone problem

Hi all,


For some reason my lock button (and power) is not working after I have recently replaced the digitiser as it was smashed..
It what was working fine beforehand any ideas what this could be?

Many thanks in advance

No Comment so far:

  1. TechGuru says:

    During the removal of the digitizer you made damage to the power button and volume and mute button flex cable , you have to change it.

  2. TechWorld says:

    Ok thanks I will get another ordered,
    I havent completely fitted the iPad digitiser yet because of this problem but when it comes to fitting the digitisers ribbon cable how do you fold it into the frame Along without damaging the cable?
    As when I lower down the digitiser for figment I have too much ribbon cable between the digitiser and frame I dont want to damage the ribbon cable

  3. newComer says:

    The power flex cable is seperated of the digitizer flex cable , it is in the opposite side , you can have a look on it , it beside the power button .

  4. Wela says:

    Yes I know, I mean as an extra question how is the digitiser ribbon cable mean too be folded so it doesnt damage

  5. newComer says:

    Follow the old digitizer ribbon , also there is a gap in the ipad body to put the extra lenght of the ribbon inside