iphone 5 short after waterdamage problematic ios stuff how to solve its hardware issue

Home  >>  iPhone  >>  iphone 5 short after waterdamage problematic ios stuff how to solve its hardware issue

iphone 5 short after waterdamage problematic ios stuff how to solve its hardware issue

On March 28, 2015, Posted by , In iPhone, With Comments Off on iphone 5 short after waterdamage problematic ios stuff how to solve its hardware issue

hi all,
i have water damage iphone 5. short circuit shows all devices (1-4 Pin is short) What is the solution


No Comment so far:

  1. baybee says:

    same problem here, any solution ?

  2. igglo7pays says:

    Hi
    I have revived a few iphones doing this way
    remove the heat shield form motherboard, clean the board Along with isapol alcahol, then check if still short if so
    connect an external power source to the two pins that is short 3.7V
    and wait till any compenent heats up and then remove the component that is hot
    usually a capacitor.
    good luck

  3. wagny says:

    /today i repired short motherbord mayb to be helped u

  4. chugowa says:

    I have the same problem, pin 1 and 4 short on battery connection.

    Android unbrik do you have a bigger picture ?

  5. kijiji says:

    You want to work out what component is shorted yourself! just because one guy replaced a capacitor doesnt mean it works for you too!

  6. baybee says:

    And what is the best way to do it, where do i start ?

    Someone here told that you have to use a external dc source to power the board so you can find the component that gets hot ?

  7. julianz says:

    That would be a good place to start, applying low voltage high current will cause to shorted component to carry all the load and therefore heat or burn giving you a visual clue. Also symptoms will to be helped you narrow down areas to look for example, touch issues could be a short in the touch IC or supplying components etc, get hold of the schematics and trace the lines.

  8. killu says:

    And what is a safe low voltage to use Along without damaging the board.

  9. TechGuru says:

    well the maximum the battery outputs is 4.2v